About Lesson
7.1 – End Cap
This section will instruct the correct procedure on how to remove and replace the End Cap.
Removal
Step 1 – The End Cap clips must be detached to release the end cap. Locate the three holes in the track and use a 2mm diameter Allen key to release the end cap clips.
Step 2 – Remove the end cap from the track as shown.
Step 3 – Repeat Steps 1 and 2 to remove the opposite end cap.
Refitting / Replacement
Step 4 – Refitting is a reversal of the removal process noting the following points:
- Refit the End Cap in the correct orientation. Ensure that the End Cap Clips locate correctly into the track for correct fitting. Loctite 401 can be used to secure a loose cap.