Course Content
TX600 – Training Manual
TX600 – Commissioning Manual
TX600 – Spare Parts Manual
The TX600 spare parts manual is a comprehensive guide that provides detailed information about the spare parts used in the TX600 machinery. It includes a parts list, descriptions, illustrations. It is a valuable resource for technicians and maintenance personnel to effectively repair and maintain the TX600 equipment.
Test Topic
TX600 (Fixed Motor)
About Lesson

9.12.1     Charging Beak – Standard (Track Type 1)

Within this section it will explain the correct procedure on removing and reinstalling the Charging Beak for servicing procedures or replacement.



Step 1 – Remove external covers off the Hoist. (refer to section 9.1)

Step 2 – Remove the Battery from the battery brackets. (refer to section (9.3)

Step 3 – Disconnect the Charging Beak from the PCB.

Step 4 – Reroute the Wire from under the Battery Bracket.

Step 5 – Cut all three Cable Tie’s that secure the wire to the Chassis.

Step 6 – Using a 2mm Allen Key, Remove the M3x12 Screws and M3 Nyloc Nuts to release the Charging Beak.


Refitting / Replacement

Step 7 – Refitting is a reversal of the removal process noting the following point:

Three cable ties are required! – Re-secure the Wire with cable ties as instructed below:

A1) Insert the cable tie (100mm x 2.5mm) through the top hole in the Chassis plate and along the back of the red and black wires.

A2) Fold the cable tie around the Black wire and pass the cable tie back through the hole and over the Red wire.

A3) Tie the cable tie retaining the Black wire and Red wire.

A4) Repeat this process for the second cable tie. For the bottom hole a cable tie 100mm x 2.5mm can be passed through the hole then around the Black and Red wires and tied off. Finally, snip of the surplus cable once secured.