Course Content
TX600 – Training Manual
TX600 – Commissioning Manual
TX600 – Spare Parts Manual
The TX600 spare parts manual is a comprehensive guide that provides detailed information about the spare parts used in the TX600 machinery. It includes a parts list, descriptions, illustrations. It is a valuable resource for technicians and maintenance personnel to effectively repair and maintain the TX600 equipment.
Test Topic
TX600 (Fixed Motor)
About Lesson

9.12.2 – Charging Beak – Track Type 2, 3, 4, 5 and Powered Auxiliary

Within this section it will explain the correct procedure on removing and reinstalling the Charging Beak for servicing procedures or replacement.


Step 1 – Remove external covers off the Hoist. (refer to section 9.1)

Step 2 – Remove the Battery from the battery brackets. (Refer to section (9.3)

Step 3 – Disconnect the Charging Beak from the PCB.


Step 4 – Reroute the Wire from under the Battery Bracket.

Step 5 – Cut the cable tie that secure the wire to the Chassis.

Step 6 – Using a Pozi Screwdriver, remove the screws to release the Charging Beak.

Refitting / Replacement

Step 7 – Refitting is a reversal of the removal process noting the following point:


1. One cable tie is required! – Re-secure the Wire with cable tie as instructed below:

Pass through the cable tie (100×2.5mm) through the hole and tie to secure the wire to the chassis. Snip the surplus cable once secured.