Course Content
TX600 – Training Manual
TX600 – Commissioning Manual
TX600 – Spare Parts Manual
The TX600 spare parts manual is a comprehensive guide that provides detailed information about the spare parts used in the TX600 machinery. It includes a parts list, descriptions, illustrations. It is a valuable resource for technicians and maintenance personnel to effectively repair and maintain the TX600 equipment.
Test Topic
TX600 (Fixed Motor)
About Lesson

4.2.8 Installing the Power Supply to Constant Charge – (Track Type 3)

To install the TX Charger, follow the guidance below:

1. Complete all relevant steps in 4.1 to gain access to the Ceiling Track.

2. A step ladder is recommended for easier and safer installation.

3. Place a positive and negative sticker on either side of the track, (if there isn’t any already). 

4. Remove the current charging unit from the track by pulling out the jack plug.

5. Remove the charging unit from the socket and any fixings to the wall (where applicable)

6. Install the new charging unit (provided with the hoist) by plugging the jack plug into the terminal port. 

7. Route the power supply cables through the bottom of the track, to allow the end stop, safety bolt to be fitted in front and end cap to be refitted behind. 

8. Refit the end stop, safety bolt and end cap to the track. See section 4.1 for guidance.

9. Route the Charger wires in a tidy fashion to the closest power supply.

10. The Charger block locates into its bracket as shown in image. Raw Plugs and Screws are provided to fix the unit to the wall if desired.

11. Choose a suitable location on the buildings wall where the charging unit can be fitted. The wall must be of good structure to fit the three screw fixing points.

12. Drill three 7mm holes into the wall that will allow the three given brown raw plugs to be fitted, measure the gap between the three drilled holes to match the profile of the of the charging unit bracket.

13. Place the raw plugs into the drilled holes.

14. Align the charging bracket fixing point with the holes and use a pozi head screwdriver to fix the two screws and secure the bracket to the wall. 

15. Fit the Charging Unit into the Bracket.

16. Plug the Charger into the nearest wall socket and turn on the power supply.

17. The Charging Dock is ready for use.