Course Content
TX600 – Training Manual
TX600 – Commissioning Manual
TX600 – Spare Parts Manual
The TX600 spare parts manual is a comprehensive guide that provides detailed information about the spare parts used in the TX600 machinery. It includes a parts list, descriptions, illustrations. It is a valuable resource for technicians and maintenance personnel to effectively repair and maintain the TX600 equipment.
Test Topic
TX600 (Fixed Motor)
About Lesson

9.12.3     QRT System Charging Beak

Within this section it will explain the correct procedure on removing and reinstalling the QRT Systems Charging Beak for servicing procedures or replacement.



Step 1 – Disconnect the Charging Beak from the external cover plug in.

Step 2 – Cut the cable tie that secure the wire to the Chassis.

Step 3 – Using a Pozi Screwdriver, remove the screws to release the Charging Beak.

Refitting / Replacement

Step 4 – Refitting is a reversal of the removal process noting the following point:


1. One cable tie is required! – Re-secure the Wire with cable tie as instructed below:

Pass through the cable tie (100×2.5mm) through the hole and tie to secure the wire to the chassis. Snip the surplus cable once secured.